PrintLab Model 3503R - #7141

- RA-4, B/W, Duratrans
- 13" Maximum Width
- Dry-To-Dry
- Automatic Replenishment
- Computer-Controlled Operation
- Stand-By Function

 

 

 

 

 

 

 

PrintLab Model 3503 - #7140

- RA-4, B/W, Duratrans
- 13" Maximum Width
- Dry-To-Dry
- Stand-By Function

 

 

 

 

 

 

 

 

Product Line Summary:

Manufactured by JOBO, these intelligently-designed processors are suitable for up to 13"-width RA-4 and black and white prints. As with any roller-transport machine, the racks are the key to even, smooth, trouble-free printing. The design of the PrintLab ensures the paper is gently guided through the racks providing flawless processing.

PrintLabs 3503R and 3504 come pre-programmed for all RC-based B/W graded and variable contrast, and RA-4 papers. The rack design and variable temperature and transport speed controls assure you of high-quality processing.

---

Key Features

Extremely consistent
All PrintLabs develop prints evenly and consistently. PrintLabs 3503R and 3504 take this consistency one step further with automatic replenishment.  These PrintLabs use five infrared sensors to measure the surface area of the print to be developed, then calculate and pump the correct amount of replenisher chemical to the appropriate bath. (The replenishment chemicals are drawn from collapsible 5-Liter air-tight containers.)

Easy on the environment
In addition to appropriate chemical replenishment, PrintLabs 3503R and 3504 use microprocessor-control to calculate the correct amount of wash water (based on the surface area of paper developed). Model 3503 automatically stops the wash water when the processor goes into standby mode.

Ready when you are
After turning on your processor, you're ready to start developing in minutes. With PrintLab models 3503R and 3504, each bath is independently heated to its specific temperature and controlled by an independent thermostat which allows for individual programming of each chemical bath. (There is one temperature control in models 3503 and 3502.)

Special Features with PrintLab 3504
PrintLab model 3504 includes two special features to save you money and time.

The first is a built-in water heater for the rinse-water. These means only a cold-water supply is required. The other feature is a cleaning program. When the cleaning program is run the processor will automatically; drain the processing chemicals to bottles stored below, fill with water, wash the processing racks, drain itself, and wait until you're ready to start processing again.

---

Technical Specifications/Capacities:

---

Accessories:

Refilling System Filling and draining chemicals from the processing troughs is made easier with the Wall Mount and accompanying Canisters. #7151 Wall Mount Bracket #7164 Canister, Wall Mount

Chemical overflow Made of transparent plastic, these 5-Liter overflow canisters allow you to collect your used chemicals with little mess. Come complete with all necessary hoses. #7153 Overflow Canister

Sealing guide The Sealing Guide is used when the feed portion of the PrintLab is installed in a darkroom, but the processing portion of the processor is in "daylight". #7162 Sealing Guide

Replenishing chemicals To keep your replenishment chemicals fresh, use the 5-Liter collapsible container. Made with HDPE, an extremely air-tight plastic. Connects directly to the replenishment system of the PrintLab. #7163 Reusable Replenishment Container

Roll paper Increase your production with the Roll Paper attachment. The Roll Paper attachment holds over 300' of 12" roll paper. (Processor must be installed in a darkroom.) #7165 Roll Paper Attachment